admin, June 30th, 2014. LIVING ROOM, Installing Tile Flooring in the Correct Ways.
Installing tile flooring may seem easy for most DIYers. But to get the best result, it still needs careful preparation. You also need to understand the steps well and pay attention to the detail. If you are going to install tile by yourself, the first thing you need to do is preparing the substrate for sure. There is wide variety of tile types. Most types of tiles can be installed over such substrates as a mortar base, cement board, plywood subflooring, or the existing tile if your want to lay the new tile floor.
After concerning to the substrate, you can start to lay out the pattern as the first step in installing tile flooring. Here, you may need to measure the floor and snap a chalk line down on the middle of the longest dimension of floor. After you have calculated the layout perfectly, you can cut all of the tiles for row ends and corner. Do it before you start to set the tiles in the mastic. The next step you need to do is applying the mastic. Some mastic may have strong, noxious fumes and they may be volatile, so you need to make sure to extinguish any pilot lights. Also, you can provide adequate ventilation to the area of work.
After applying the mastic, you can lay the tiles. You can start at the intersection of the layout lines. Here, you need to set the tiles into the adhesive carefully. You can use hammer or rubber mallet and wood block to tap and bed each tile into the mastic applied. Next, you can place plastic spacers between each tile. The last step is about grouting the joints. Here, you may allow the tile mastic to set. Do it for at least one day before you remove the spacers and grout the joints as well. Installing tile flooring will be easier if you follow the manufacturer’s directions correctly.